Paul Lee - SQ2000 Project, Pierre SD USA

Click on images for larger view.
Factory shipped the EBX-1800 glass late - so did some other work out of sequence.

For some reason - apparently temperature in garage was too low (68F) - epoxy curing took about 24hrs. Didn't suit me. Ordered an overhead garage heater on 9/25/01 to control temperature.


Bulkhead templates/foam cut & fusel. inside foam strips

Aligning/bolting fuselage halves using calipers:


Fuselage joint (first layer) fibreglass cutting (got a good rotary cutter later from Wall-Mart):

Return to main page